|Listed in category:
The seller is away until 26 Jun, 2024. If you buy this item, expect a delay in postage.
Have one to sell?

412 Drop Forged C-Clamp 12”

Condition:
Used
Price:
US $35.00
ApproximatelyEUR 32.59
(US $35.00 / Unit)
Collection:
Free collection in person from Walton, Kentucky, United States. See detailsfor collection
Postage:
US $18.58 (approx EUR 17.30) Express Delivery. See detailsfor postage
Located in: Walton, Kentucky, United States
Delivery:
Estimated between Fri, 28 Jun and Tue, 2 Jul to 43230
Delivery time is estimated using our proprietary method which is based on the buyer's proximity to the item location, the delivery service selected, the seller's delivery history and other factors. Delivery times may vary, especially during peak periods.
Payments:
    

Shop with confidence

eBay Money Back Guarantee
Get the item you ordered or your money back. 

Seller information

Registered as private seller, so consumer rights stemming from EU consumer protection law do not apply. eBay Money Back Guarantee still applies to most purchases.
Seller assumes all responsibility for this listing.
eBay item number:315219370878

Item specifics

Condition
Used: An item that has been previously used. The item may have some signs of cosmetic wear, but is ...
MPN
412
UPC
N/A

Item description from the seller

lowryconstructionsurplus

lowryconstructionsurplus

94.1% positive Feedback
97 items sold
Usually responds within 24 hours

Detailed seller ratings

Average for the last 12 months

Accurate description
4.9
Reasonable postage cost
4.9
Delivery time
5.0
Communication
5.0
Registered as a private seller
Thereby, consumer rights stemming from EU consumer protection law do not apply. eBay buyer protection still applies to most purchases.

Seller Feedback (18)

2***w (46)- Feedback left by buyer.
Past month
Verified purchase
Very good
e***s (191)- Feedback left by buyer.
Past month
Verified purchase
It's functional. I saw the rust in the pictures and I was able to clean it up so I have no complaints for the price.
c***y (82)- Feedback left by buyer.
Past month
Verified purchase
This bull pin taper, is the exact tool I needed for the job at hand and it arrived just in time. The only reason that I didn’t give a fifth star is that the tool, as pictured, showed a cross bar handle for twisting and bucking two stubborn holes into alignment. Fortunately, I did not need that handle then. This tool arrived without that handle. I was understandably disappointed, but used it anyway because it’s need was immediate.
Reply from: lowryconstructionsurplus- Feedback replied to by seller lowryconstructionsurplus.- Feedback replied to by seller lowryconstructionsurplus.
Apologize for you looking for a handle. There are no handles shown in any pictures, just a bull pin and a tape measure for sharing sizes. The hole in the bull pin is for attaching a safety tie-off lanyard to prevent the pin from falling from the beam or worker to the ground below.